Home > Knowledge > How to Interpret Plasticizer Purity, Acid Value and Density in a COA | Henan GO Biotech Co., Ltd.

How to Interpret Plasticizer Purity, Acid Value and Density in a COA

Henan GO Biotech Co., Ltd.
2026-11-06
Product Introduction
Henan GO Biotech Co., Ltd. explains how to interpret purity, acid value and density in a plasticizer COA and compare results with product specifications.

A certificate of analysis (COA) reports test results for a specific batch of material. For plasticizer buyers and processors, purity, acid value and density are useful checkpoints—but each result should be read against the relevant plasticizer product specification, test method and reporting conditions.

Start with the product and batch

Before reviewing individual values, confirm that the COA identifies the plasticizer and batch supplied. Compare the reported results with the agreed specification for that product, including the units, acceptance limits and referenced test methods.

Different plasticizers have different compositions and physical properties. A result that is appropriate for one product should not automatically be used as the benchmark for another.

Purity: understand what the percentage measures

Purity indicates the proportion of the target substance as defined by the analytical method. It is commonly reported as a percentage, but the basis of that percentage matters. For example, a chromatographic area percentage is not necessarily the same as a mass percentage.

Check the specification and test method before comparing purity values. A higher reported percentage alone does not establish suitability for every formulation or demonstrate compliance with a particular regulation.

Acid value: check the limit and unit

Acid value is a measure of acidic constituents in a sample. It is commonly expressed in milligrams of potassium hydroxide required to neutralize the acidity in one gram of sample (mg KOH/g).

Compare the result with the maximum limit and method stated in the product specification. Acid value is one quality indicator; it does not identify every impurity or, by itself, predict how the plasticizer will perform in a finished product.

Density: read the temperature as well as the value

Density describes mass per unit volume and may be reported in units such as g/cm³. Because liquid density changes with temperature, the measurement temperature is essential when comparing a COA result with a specification or another result.

Confirm the unit, temperature and test method, then check whether the result falls within the specified range. Density can support a product identity or consistency check, but it cannot establish purity on its own.

A practical COA review checklist

  1. Match the product name and batch identification to the material supplied.
  2. Use the applicable product specification and agreed acceptance limits.
  3. Check each result’s unit and test method, including the basis used for purity.
  4. For density, verify the measurement temperature before comparing values.
  5. Ask for clarification if a result, method or reporting condition is missing or unclear.

Discussing results with your supplier

As a reliable plasticizer supplier, Henan GO Biotech Co., Ltd. offers a full portfolio of plasticizers for B2B applications. When reviewing a COA, buyers and processors can share the product name, batch details and applicable specification with us to clarify reported results. Final material suitability should be assessed against the intended formulation and its relevant requirements.

Recommended Reading

Hot Products

Popular Articles

How to Interpret Plasticizer Purity, Acid Value and Density in a COA
How to Interpret Plasticizer Purity, Acid Value and Density in a COA
How to Interpret Plasticizer Purity, Acid Value and Density in a COA
How to Interpret Plasticizer Purity, Acid Value and Density in a COA
How to Interpret Plasticizer Purity, Acid Value and Density in a COA
NAME *
EMAIL ADDRESS *
PLEASE CHOOSE
COUNTRY
What is the main application of the product?
Which product do you need?
How many tons do you need?