DEHCH vs ATBC: Plasticizer Selection for Water-Based Food Packaging Inks
DEHCH and ATBC are non-phthalate plasticizer candidates for water-based acrylic packaging inks. Both warrant formulation trials when replacing a phthalate plasticizer, but neither should be selected on composition alone. Resin compatibility, film performance, migration, odor and applicable food-contact requirements all need to be assessed for the intended use.
How DEHCH and ATBC fit different formulation priorities
DEHCH: a candidate for low-migration requirements
DEHCH low-migration non-phthalate plasticizer is a candidate to evaluate when a packaging ink must balance flexibility, low odor and migration requirements. In a water-based acrylic ink, its suitability depends on compatibility with the specific resin and water-phase formulation, as well as the finished ink’s performance.
ATBC: a candidate for flexible, low-odor films
ATBC low-temperature flexible citrate plasticizer is worth evaluating where flexibility, clarity and low odor are priorities.It may be considered for water-based packaging inks, including formulations that need flexibility at low temperatures. Compatibility and finished-film properties should be verified in the intended ink system.
These are starting points rather than universal rankings. A direct comparison under the same formulation and test conditions is needed to determine which candidate better meets a particular project’s requirements.
What to assess in a water-based acrylic ink
- Resin and water-phase compatibility: Assess whether the plasticizer can be incorporated into the acrylic system and whether the formulation remains stable during storage and application. Check for separation, changes in viscosity and visible defects.
- Film flexibility and adhesion: Test the dried ink on the intended substrate, including bending or folding where relevant. Evaluate adhesion and performance at the expected storage and use temperatures.
- Appearance and processing: Review flow, drying behavior, film uniformity, clarity and gloss against the printing process and product specifications.
- Migration, odor and VOC emissions: Evaluate the finished formulation under conditions relevant to the packaging application. Results depend on the complete ink, substrate, processing conditions and test method.
A practical comparison and trial process
- Define the application. Identify the acrylic resin, substrate, printing and drying conditions, expected service temperature and packaging use.
- Prepare comparable trials. Evaluate DEHCH and ATBC in the intended formulation. Determine suitable addition levels through trials rather than assuming a direct replacement ratio.
- Test the ink and printed film. Check formulation stability, processability, appearance, flexibility and adhesion, followed by migration, odor and VOC testing as required.
- Confirm the final choice. Compare the results with the project’s performance criteria, product documentation and applicable regulatory requirements before scale-up.
Food-contact suitability requires finished-article assessment
Non-phthalate status does not by itself establish suitability for food packaging. Requirements depend on the destination market, the intended contact conditions, the packaging structure and the applicable rules for each component and finished article.
Review product-specific documentation and applicable regulations, and carry out relevant migration and finished-article testing. Do not assume that a plasticizer is approved for every food-contact application or that a result for one formulation applies to another.
Discuss your formulation requirements
Henan GO Biotech Co., Ltd. supplies plasticizers and provides application selection support for coatings and inks. Share your resin system, substrate, processing conditions, performance targets and destination market to help identify DEHCH or ATBC candidates for evaluation.
Hot Products
Popular Articles






